It's commonly used by athletes recovering from soft tissue injuries like rotator cuff strains, ACL/MCL tears, and elbow or knee tendonitis
Problem: Powder won't dissolve completely Causes: Water too cold Not enough time Damaged peptide Solutions: Let sit for 5-10 minutes undisturbed Gently swirl (don't shake) Warm hands around vial (body heat helps) If still not dissolving after 15 minutes, peptide may be degraded Problem: Solution is cloudy or has particles Causes: Contamination Degraded peptide Improper storage before reconstitution Solutions: Do not use cloudy solution Discard the vial Contact vendor for replacement Never inject cloudy peptides Problem: Can't draw liquid from vial Causes: Vacuum in vial Needle blocked Solutions: Inject air into vial before drawing (equal amount to what you're withdrawing) Make sure needle tip is below liquid level Use fresh needle if current one is blocked Problem: Injection site reactions Causes: Injecting too fast Not rotating sites Contaminated peptide Solutions: Inject slower (10 seconds minimum) Rotate sites minimum 1 inch apart Check for cloudiness before injection If reactions persist, discard vial Problem: Uncertain about concentration Causes: Forgot to label vial Added wrong amount of water Mixed up multiple vials Solutions: Always label immediately after reconstitution Use our peptide reconstitution calculator and write exact concentration on vial When uncertain, discard and start fresh (better safe than wrong dose) Reconstitution for specific peptides Quick reference for common peptides
Vitamin B12 is a nutrient that provides supplements to the body to keep your blood and nerve cells healthy while aiding to make DNA, which is the genetic material in all of your cells
Can J Anaesth 1995;42:878 7
I always feel a bit uncomfortable about admitting to doing things unconventionally but I now confess if I had stored them like Alex and I do, ie in a cool, dark and dry place, I probably wouldn't have any qualms about using them myself even 5 years beyond their expiry dates
A vial isnt just 5mg or 10mg in isolation that mass has to be matched against the intended use volume, and the same mass can support meaningfully different concentrations depending on how much diluent is introduced
