ProFloat XD60 for the 2018-Current Jeep Wrangler JL Dodge Ram 2500 We recommend using a Dynatrac

We recommend using a Dynatrac Installation Kit to make installing these balljoints easier

we recommend using a BulletProof Locking Pin to keep your receiver shackle secured onto your vehicle

For optimal performance

On 2012-2018 model Jeep JKs this is also required for the drive shaft to clear the factory cross member that runs below it

providing a major improvement over the construction of the stock units

ProFloat XD60 for the 2018-Current Jeep Wrangler JL Dodge Ram 2500 We recommend using a DynatracEveryone else's full float axle just became obsolete. The Dynatrac ProFloat XD60 is a proprietary system of axleshaft, housing and bearing technology that virtually eliminates axle flange bending, even with tires up to 40 inches in diameter. This ProFloat XD60 is a direct bolt in for the 2018 current Jeep Wrangler (JL). Dynatrac has once again rewritten the rulebook of axle strength and durability. With the introduction of the ProFloat XD60 axle,