Gravity: Arduino Shield HAT for Raspberry Pi _MAKE_MODULE_LORA When you're ready to go

When you're ready to go

10x - 10K ohm 5% axial resistors

you can check his blog

Each order comes with a Servo HAT

If you want to connect to the input of a 5 meter cable (to wire it to power and a microcontroller) please use the plug connector

Gravity: Arduino Shield HAT for Raspberry Pi _MAKE_MODULE_LORA When you're ready to goThis clever HAT from DFRobot adds an Arduino (ATmega32u4) on top of your Raspberry Pi, giving you the very best of both worlds for your projects! The HAT has broken out pins from both your Raspberry Pi GPIO and the onboard ATmega32u4, alongside an XBee socket (with Pi serial Arduino serial switch), RTC reset button (Arduino), SDA SCL breakouts. A bidirectional logic converter has been included, which converts your Raspberry Pi GPIO signal voltage